OMC 1999 40/50 4-Stroke Essential Service Tool Kit - 787076

OMC P/N 787076

OMC 1999 40/50 4-Stroke Essential Service Tool Kit, P/N 787076. Factory packing instructions identify ten tools, labeled A through J, for basic service procedures on 1999 (EE) 40/50 4-Stroke and newer outboards.

This kit includes outboard service tools required to perform basic service procedures on 1999 (EE) 40/50 4-Stroke and newer outboards. A brief description of each tool application is included in this packing slip. The 1999 40/50 4-Stroke Service Information Supplement and future OMC Service Manuals will review the use of each tool.

The factory instructions state that these tools will mount to a new tool panel kit for 4-Stroke outboards, which was described as forthcoming at the time.

Factory diagram of 1999 OMC 40/50 4-Stroke Essential Service Tool Kit 787076 with parts labeled A through JView full-size factory diagram
Factory tool identification diagram - A through J

Tools included

ItemTool and part numberFactory application
ATappet Holder
P/N 345832
Used to compress valve spring to remove and install shims when performing tappet clearance adjustments.
BRemover
P/N 345831
Used with OMC Slide Hammer, P/N 391008, to remove propeller shaft, bearing housing, and gear assembly from gearcase.
CSeal and Bearing Installer
P/N 345829
Installs gearcase driveshaft seals, driveshaft bearing, and water pump housing seal.
DSeal Installer
P/N 345830
Installs propeller shaft seals into propeller shaft bearing housing.
EDriveshaft Holder
P/N 345834
Retains driveshaft when removing and installing the pinion nut.
FBearing Installer
P/N 345835
Installs both needle bearings into propeller shaft bearing housing.
GBearing Race Installer Kit
P/N 5000008
Used with OMC Drive Handle, P/N 311880, to install forward bearing race into gearcase.
HPinion Bearing Remover/Installer Kit
P/N 5000009
Used with components of OMC Pinion Bearing Kit, P/N 391257, to remove and install pinion bearing into gearcase.
IBacklash Indicator
P/N 345836
Snaps onto driveshaft and used with dial indicator to check gearcase backlash.
JScrew and Washer Kit
P/N 5000007
Used with components of OMC Universal Puller Set, P/N 378103, for flywheel removal on 40/50 and 70 4-Stroke models. Three screws and washers are used for 40/50 and four screws and washers are required for 70 models. This kit supersedes OMC Screw and Washer Kit, P/N 437957.
Photograph of actual OMC Essential Service Tool Kit 787076 componentsView full-size kit photograph
Photograph of service tools from the kit

Available on eBay

eBay is typically the best, if not only, place for new, NOS, and used tools. As an eBay Partner, EverythingOutboards may earn a commission if you make a purchase through these links.

Checking current eBay listings…

Listings are from independent sellers. Prices and availability may change.

Referenced in: