
SB-#1001
February 5, 1964
SUBJECT: REMOVING NEW MOTORS FROM SHIPPING CARTON.
APPLIES TO ENGINES: 28 HP, Models RX(L)
40 HP, Models RD, RDS and RK(L)
60 HP, Models VX(L)
75 HP, Models V4S and V4A(L)
90 HP, Models V4M(L)
The following procedure is recommended for removing engines of 28 HP or larger from
the shipping carton to prevent damaging the shroud.


Fig. 1
Fig. 2
1. Stand carton upright so that end marked "Open This End" is facing down (Fig.1).
2. Reach in the carton and release the shroud latch. Lift shroud off of engine
(Fig. 1).
NOTE: Remove wire securing electrical cable to shroud latch on 90 HP engines
before unlatching shroud.
3. Remove carton liner from carton (Fig. 2).
Over
PAGE 2 SERVICE BULLETIN SB-1001
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086
4. Proceed to remove motor from carton by
hooking overhead hoist or portable
floor hoist to engine lifting bail
(Fig. 3).

Those not having a hoist can carefully
lay the carton on its side after
completing steps 1, 2 and 3, and
pull the motor from the carton by
the lifting bail (Fig. 4).
Fig. 3

Fig. 4
Dealers should caution their shop personnel against careless handling when un-
loading a cartoned engine from the back of a truck. Engines should never be
dropped to the ground - not even the last foot or so. Always set the carton
on the ground gently and squarely on one end.
Shop personnel should also be cautioned against handling shrouds in a careless
manner once they are unpacked.
Sincerely,
JOHNSON MOTORS
Robert Compton
RC:eb
NOTE: Post on your RX-28 HP, RD,RK-40HP,VX-60HP, V4-75HP, and V4M-90HP indexes
under the heading Miscellaneous.