Johnson Service Bulletin SB-1003 - Loose Exhaust Housing Cover Screws

February 27, 1964. Factory guidance for inspecting and retorquing exhaust housing cover screws on 75 HP Johnson outboards, including replacement hex-head screw 310861.

Johnson Motors gray factory service bulletin letterhead
SB-1003
February 27, 1964
SUBJECT: LOOSE SCREWS - EXHAUST HOUSING COVER TO LOWER MOTOR COVER - 75 HP ENGINES.
We have received a few reports from the field indicating that a loss of torque tension (looseness) has occurred on screws which secure the front and rear exhaust housing covers to the lower motor cover. These reports generally pertain to 75 HP engines being used only in rough waters.
The length of these screws has been increased on 1964 - 75 HP engines and screw head design has been changed from slotted head to hex head. Longer thread length provides increased thread engagement for greater holding power, and hex head design permits the use of a 5/16 socket when torquing the screws. Torque tension remains the same - 5-7 foot pounds or 60-80 inch pounds.
Factory Figure 1 showing 75 HP exhaust housing cover screws
Fig. 1
The condition mentioned here has not found to occur under normal usage; however, since it cannot always be established as to the type of usage each engine has had, we feel that dealers should check these screws on each 75 HP engine that is serviced. If loose screws are found, they should be re-torqued. (Refer Fig. 1).
Those who want can use the new hex head screws on pre 1964 engines to provide easier torquing. It would be desirable to replace at least the two front screws with hex head type since these are found to loosen first. The two front screws are located immediately above the swivel bracket.
Part number of the new hex head screw is #310861. This is a sems type screw and is accordingly equipped with a lockwasher.
Sincerely,
JOHNSON MOTORS Robert Compton Administrative Assistant
RC:eb
NOTE: Post on your V-4 75HP index under the heading "Lower Unit".