Johnson Service Bulletin SB-1005 - Propeller Pin Usage

Issued February 21, 1964. Johnson clarified the correct propeller pin for 10 H.P. motors according to whether the propeller uses a slip clutch hub.

Johnson Motors Service Bulletin letterhead
February 21, 1964
SUBJECT:   Propeller Pin Usage - 10 H.P. Motors.

At present we are recommending the use of two different propeller pins for 10 H.P. motors.

One pin is listed as service part 301923 and is made of brass. This is a shear pin and should be used with only those propellers that Do Not Have a slip clutch hub.

The other pin is listed as service part 307949 and is made of stainless steel. This pin is a drive pin, designed for use with only those propellers that Have a slip clutch hub.

When replacing propeller pins on 10 H.P. engines, especially models QD-10 thru 17B, check the propeller hub design before selecting a pin:

Use brass pin 301923 for non-slip clutch props.

Use Steel pin 307949 for slip clutch props.

All 10 H.P. propellers that have a slip clutch hub also have the fish-line cutter feature on the gearcase side of the hub (notches in outside of hub). Use this as a guide to help select the correct propeller pin.

JOHNSON MOTORS
Robert Compton
Administrative Assistant
RC:eb
NOTE: Post on your QD-10 HP index under heading
      "Lower Unit".