Johnson Service Bulletin SB-1016 - Testing Ignition Coil
Issued April 16, 1964, this bulletin explains testing ignition coil 379569 on 75 and 90 H.P. Johnson outboards with the Stevens Magneto Analyzer and MA-12 adapter, including bench testing, dielectric leakage testing and on-engine testing.
April 16, 1964
SUBJECT: Testing #379569 Ignition Coil with STEVENS MAGNETO ANALYZER.
Applies to Engines: 75 HP Models (V4A(L)-16D) 90 HP Models (V4M(L)-10S)
Fig. 1Fig. 2
Part #379569 battery ignition coil can be tested with the STEVENS MAGNETO ANALYZER provided a special test adaptor (Fig. 1) is used in the secondary circuit (tower) of the coil. Because of the coils high voltage output, this test adaptor (resistor) is necessary to obtain an accurate coil test, as well as to protect the analyzer from possible damage which may result from repeatedly feeding high, unaltered, secondary voltage back into the test instrument.
Testing procedure is outlined as follows.
1. TESTING COIL OFF OF ENGINE (BENCH TESTING) FIG. 2.
a. Set analyzers AB switch to B position.
b. Move selector switch to position marked COIL INDEX.
PAGE 2 SERVICE BULLETIN #1016 JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086
c. Depress and hold COIL TEST SWITCH while bringing meter pointer to index number 20 with COIL INDEX ADJUSTMENT knob. Release TEST SWITCH.
d. Insert No. MA-12 test adaptor into secondary circuit (tower) of coil.
e. Connect black primary wire from analyzer's two lead harness to coils negative (-) terminal (A, Fig. 2).
f. Connect red primary wire from analyzer's two lead harness to coils positive (+) terminal (B, Fig. 2).
g. Attach red secondary wire to test adaptor's terminal (C, Fig. 2).
h. Set selector switch to COIL TEST - depress COIL TEST SWITCH.
Condition of coil is determined by noting position of meter needle as it comes to rest in red/green band marked COIL TEST. (green-good coil) (red-faulty coil).
Fig. 3
Test coil for dielectric leaks by proceeding as follows with coil hooked to meter as described in steps 1e, 1f and 1g.
i. Depress and hold COIL TEST SWITCH while moving free end of test prod over entire surface of coil (Fig. 3).
If dielectric leakage is present, meter pointer will drop out of green range and an electric arc will be observed at free end of prod.
NOTE: Possible arcing will occur if prod is moved too close to test adaptor.
2. TESTING COIL ON ENGINE. Part #379569 coil can be tested on the engine by using No. MA-12 test adaptor after all coil leads have been disconnected; however, only bench testing is recommended.
The MA-12 test adaptor is available only from the STEVENS EXPERIMENTAL CO., 2015 Grand Avenue, Waukegan, Illinois, at the net unit price of $1.90. (Illinois resident dealers add 4% state sales tax). Prepayments must accompany orders as indicated on the enclosed order form.
DO NOT order test adaptors from Johnson Motors, Outboard Marine Corporation Parts Depot nor from your parts distributor.
JOHNSON MOTORS Robert Compton Administrative Assistant
RC:eb
NOTE: Post on V4-75 HP and VM-90 HP indexes under heading "IGNITION".
Historical parts and tools references
379569 - Battery ignition coil. MA-12 - Stevens Magneto Analyzer test adapter, listed at $1.90 in 1964. The bulletin recommends bench testing and describes how the adapter protects the analyzer from high secondary voltage.