Johnson Service Bulletin SB-1017 - Flywheel Key Installation

April 29, 1964. Factory instructions for correct flywheel key installation and magneto cam alignment on 3, 5½, 9½, 10 and 18 HP Johnson outboards.

Johnson Motors gray service bulletin letterhead
SB-1017
April 29, 1964
SUBJECT: FLYWHEEL KEY INSTALLATION
ON ENGINES: 3 HP 5½ HP 9½ HP 10 HP 18 HP
When inserting the flywheel key into the crank- shaft keyway of any engine listed above, be sure the single upset mark on the side of the key (Fig. 1) is facing down. Correct installation of this key is important, since it also engages and positions the magneto cam in proper relationship with the crankshaft for precise ignition timing. This upset assures a tight fit between the key and the cam, therefore, if the key is incorrectly installed, the cam may become loose on the crankshaft to result in late (retarded) ignition timing.
Original factory Figure 1 showing flywheel key installed with upset mark facing down
JOHNSON MOTORS Robert Compton Administrative Assistant
RC:eb
NOTE: Post on JW-3 HP, CD-5½ HP, MQ-9½ HP, QD-10 HP and FD-18 HP indexes under heading "IGNITION".

Installation reference

Install the flywheel key with its single upset mark facing down. The correct orientation secures the magneto cam and maintains proper ignition timing.