Johnson Service Bulletin SB-1019 (1964)

Issued October 20, 1964, this Johnson Motors service bulletin explains how to eliminate electrical resistance caused by oxidation on newly installed ignition breaker points. It distinguishes procedures for two-cylinder engines, V4 magneto ignition, and V4 battery ignition, and warns against filing or solvent cleaning.

Johnson Motors Service Bulletin letterhead

October 20, 1964

SUBJECT:  ELIMINATING BREAKER POINT RESISTANCE ( NEW BREAKERS ONLY).

High resistance may occasionally be noted between the contacting surfaces of new breaker points after they have been installed on an engine. This condition usually shows up when a continuity meter is hooked across the points to facilitate making point adjustment.

Such high resistance conditions result from oxidation of the tungsten contacting surfaces during breaker-point storage. The problem is not a critical one, however, since it can easily be corrected in the service shop. Anyone experiencing this condition should not condemn the points as being faulty but should open and close the points under electrical load several times before attaching a continuity meter to make adjustment. A slight electrical arc will occur between the contacts as the points open which will be sufficient to remove this oxidation.

Breaker-point oxidation can be removed from new points installed on a two cylinder engine by setting the flywheel on the crankshaft and turning it over by hand several times after first setting the points to approximately .020". On V4-magneto models the same effect is accomplished by installing the drive pulley and rotating it several times after the points have been set to approximately .020". On V4 battery-ignition models it is suggested that first one set of points be adjusted closed, the key turned to "on" position and the points opened and closed several times by snapping the rubbing block end of the moveable arm. The first set of points should then be adjusted opened, the second set closed and the same procedure repeated for the second set.

CAUTION

When utilizing this procedure for two-cylinder engines the spark plug leads should be grounded with short jumper lead to prevent accidental starting of the engine.

Once breaker point resistance has been eliminated, proceed to attach a continuity meter across the breaker points and adjust each set of points in the normal manner.

The procedure outlined here is the only satisfactory method for removing oxidation from breaker points. Never attempt to remove oxidation by filing the contact surfaces nor by using liquid cleaning solvents. Filing contacts often leads to severe pitting and use of cleaning solvents oftentimes leaves residue on the contacting surfaces that leads to point burning.

NOTE:  Post on your miscellaneous index under "ENGINE MISCELLANEOUS".

RC/ll

JOHNSON MOTORS

Robert Compton

Administrative Assistant

Historical service reference

This bulletin applies specifically to new breaker points. The factory procedure uses normal electrical operation of the contacts to remove oxidation before a continuity-meter adjustment. Its warning against filing and solvents is part of the original instructions.

Browse other 1960s Johnson service bulletins