Johnson Service Bulletin SB-1020 - Steering-Pulley Plate Installation

May 15, 1964. Factory instructions for fitting the improved steering-pulley plate mounting hardware to earlier Johnson 90 HP outboards.

Johnson Motors gray service bulletin letterhead
SB-1020
May 15, 1964
SUBJECT: STEERING-PULLEY PLATE INSTALLATION - 90 HP ENGINES.
Dealers who have rigged some of the later 90 HP engines have probably noticed that we are now using longer screws, two lockwashers and a nut to secure the steering- pulley plate to the bottom of the front lower motor cover (these parts will be found in the tool kit). On earlier 90 HP engines only two short screws were used in this application.
The longer screws, lockwashers and nut provides an improved pulley-plate installation to the engine. Anyone desiring to install these parts on earlier 90 HP engines should order the following items from their parts distributor:
2 pcs. #308743 SCREW 2 pcs. #302290 LOCKWASHER 1 pc. #301472 NUT
Parts required per motor.
Install as follows:
(A) Forward Screw - assemble thru pulley plate and motor cover; lockwasher and nut installed from top side of lower motor cover.
(B) Rear Screw - assemble lockwasher to screw; insert screw thru plate and secure to motor cover.
JOHNSON MOTORS Robert Compton Administrative Assistant
RC:eb
NOTE: Post on your V4M - 90 HP index under heading "MISCELLANEOUS".

Hardware and installation reference

For earlier 90 HP engines, use two 308743 screws, two 302290 lockwashers and one 301472 nut. The forward screw uses a lockwasher and nut above the lower motor cover; the rear screw uses a lockwasher and threads into the cover.