Johnson Service Bulletin SB-1021 - Modification to Improve Engine Idle

Issued May 15, 1964, this bulletin instructed Johnson dealers to add four exhaust relief holes to the exhaust housing of 1964 3 HP JW and JH engines to improve idle characteristics. The factory instructions and illustration are reproduced below.

Johnson Motors Service Bulletin gray letterhead

May 15, 1964

SUBJECT:  MODIFICATION TO IMPROVE ENGINE IDLE.

ON ENGINES:  1964 - 3 HP (Models JW & JH)

Engine idle characteristics can be improved on all 1964 - 3 HP engines by drilling four (4) additional exhaust relief holes in the exhaust housing. See Fig. 1. Use a 3/32" dia. drill to perform this modification.

The four additional holes should be drilled at the same angle as the original holes. This can be accomplished by starting drill straight into housing and then slowly and carefully tilting drill to obtain an angle of approximately 15°.

All new 1964 - 3 HP engines should be modified as described above before being turned over to the customer, as should any engine already in use that is brought into the shop for service. Eventually these four additional holes will be added to all 3 HP engines by the factory on the production line.

Figure 1: Johnson 3 HP lower unit with four additional 3/32 inch exhaust relief holes evenly spaced between existing holes
Fig. 1

JOHNSON MOTORS

Robert Compton

Administrative Assistant

RC:eb

NOTE: Post on 3 HP - JW, JH index under heading "LOWER UNIT".

Historical service reference

Application: 1964 Johnson 3 HP, JW and JH models. Modification: Four additional 3/32-inch exhaust relief holes, spaced between existing holes, drilled at approximately 15° as described in the original bulletin. The original factory illustration is retained for context.

Return to 1960s Johnson service bulletins