Johnson Service Bulletin SB-1022 - Throttle Cable Anchor Assembly

Issued May 22, 1964, this bulletin shows the assembly order and lubrication requirements for the throttle cable anchor used on 1964 Electramatic outboards.

Johnson Motors Service Bulletin gray factory letterhead

May 22, 1964 SB-1022

SUBJECT:  INSTALLATION AND LUBRICATION OF THROTTLE CABLE ANCHOR ASSEMBLY.

ENGINES:   ALL 1964 "ELECTRAMATIC" MODELS (40, 75 & 90 HP).

Figure 1 illustrates correct assembly sequence for the new style throttle-cable clamping arrangement used on all 1964 "Electramatic" models. Note that the smaller diameter of the spacer is to be located inside of the spring lock mounting hole.

Exploded view showing 310686 screw, 310688 spacer, 310687 spring lock and 310685 anchor block
Fig. 1

To insure that the spring lock will always turn freely for cable removal or installation, we are suggesting that both sides of the spring lock be lubricated in the area of the mounting hole - prior to initial assembly. Use OMC Type "A" lubricant.

JOHNSON MOTORS
Robert Compton
Administrative Assistant

RC:eb

NOTE:  Post on RD, RK-40 HP, V4-75HP and V4M-90 HP indexes,
      under heading "Miscellaneous".

Parts referenced in SB-1022

Figure 1 identifies screw 310686, spacer 310688, spring lock 310687, and anchor block 310685. The bulletin specifies OMC Type A lubricant for the spring lock mounting area.