Johnson Service Bulletin SB-1023

Issued May 28, 1964, this bulletin describes a tilt-lock pin engagement problem on 1964 Johnson 28 and 40 H.P. outboards, with a factory photograph identifying the pin and swivel-bracket hole.

Johnson Motors Service Bulletin letterhead

May 28, 1964

SUBJECT:  TILT-LOCK PIN NOT ENGAGING WITH HOLE IN SWIVEL BRACKET.

ON ENGINES:  1964 - 28 and 40 H.P. Models.

The hole for the tilt-lock pin in the swivel bracket of some 1964 - 28 and 40 HP engines may be "off location" slightly, preventing engagement of the tilt-lock pin.

Dealers experiencing this condition on any of the above listed models should enlarge the side of the hole that prevents pin engagement with a rat-tail file until the pin will engage. Once the enlargement is made, the bare-metal area should be retouched with French-Silver Paint to prevent corrosion.

Factory photo showing tilt-lock pin and tilt-lock pin hole on Johnson outboard
JOHNSON MOTORS
Robert Compton
Administrative Assistant

RC:eb

NOTE:  Post on RX-28 HP and RD, RK-40 HP indexes under heading "LOWER UNIT".

Historical service reference

Applies to: 1964 Johnson 28 and 40 H.P. engines. The factory directs dealers to file this bulletin under Lower Unit. The illustrated repair concerns the tilt-lock pin and its mating hole in the swivel bracket.