Johnson Service Bulletin SB-1027 - Stronger Reverse-Lock Springs

September 3, 1964. Factory guidance on strengthened reverse-lock springs for heavy-duty 60 and 75 HP engines, including production serial numbers and identification tests.

Johnson Motors gray service bulletin header
SB-1027
September 3, 1964
SUBJECT: STRONGER REVERSE-LOCK SPRINGS FOR HEAVY-DUTY ENGINES.
MODELS: 60 HP, VXH (L)-11C 75 HP, V4H (L)-17S
Stronger reverse-lock springs are now being installed on 60 and 75 en- gines equipped with heavy-duty (high-thrust) lower units to prevent the engine from jumping out of lock position when shifting into reverse gear. Starting serial numbers of production engines on which these springs have been added are as follows.
MODEL STARTING SERIAL NO. HORSEPOWER RATING VXH-11C 2517762 60 VXHL-11C 2517792 60 V4H-17S 2518182 75 V4HL-17S 2493459 75
We suggest that strengthened reverse-lock springs be installed on all heavy-duty engines already in the field that were made prior to the se- rial numbers shown above (1964 models included). These strengthened springs are available individually as service part 311441.
A red dykem mark has been painted on one end of part 311441 spring for identification purposes, since it is almost identical in size to the pre- sent standard-unit spring (305642). However, springs that are covered with a finish coat of engine enamel can be identified by stretch test. A twenty-pound weight will stretch part 305642 spring to an over-all length of approximately 5 and 5/16 inches. A forty-pound weight will stretch part 311441 spring to an over-all length of approximately 5 and 7/16 inches.
When attempting to identify reverse-lock springs by stretch test, use the twenty-pound weight first to avoid exceeding the elastic limit of part 305642 spring.
Sincerely,
JOHNSON MOTORS Robert Compton Administrative Assistant
RC/ll
NOTE: Post on VX-60HP and V4-75HP indexes under "LOWER UNIT".

Related bulletin

This bulletin supplements , which describes the earlier slow-speed needle adjustment procedure.