Johnson Service Bulletin SB-1028 - Spark Plug Fouling, No. 4 Cylinder

Issued September 3, 1964, this Johnson Motors bulletin addresses wet fouling of the fourth spark plug on 50 through 90 HP V4 outboards. It explains a fuel-pump diaphragm check and identifies other possible causes. The second factory page includes a labeled engine photograph showing wiring and starter connections.

Johnson Motors Service Bulletin letterhead

September 3, 1964

SUBJECT: SPARK PLUG FOULING - #4 CYLINDER

ON ENGINES: ALL V4 SERIES (50 THRU 90 HP).

Continual wet fouling of #4 spark plug on any V4 series engine may be the result of a faulty fuel pump diaphragm.

To check for such a condition, simply remove the hose from the fuel pump cover that connects the pump with #4 crankcase. If fuel can be made to discharge from the nipple in the fuel pump cover by squeezing the primer bulb, the pump diaphragm is defective and requires replacement. In this instance, the defective diaphragm is allowing fuel to be drawn into #4 crankcase which, in turn, floods the cylinder to wet foul #4 spark plug.

When replacing a defective pump diaphragm, examine both diaphragm spring supports for sharp edges or irregularities which could have caused the failure. Defective supports must also be replaced.

In the event wet fouling of #4 spark plug cannot be traced to a faulty fuel pump diaphragm, do not overlook other probable causes which could create this same problem - such as:

(a) obstruction in #4 crankcase drain system.
(b) loose bottom crankcase end-head.
(c) improperly installed connector on #4 spark plug lead.
(d) overly rich slow-speed needle adjustment on bottom cylinder (90 HP).
(e) bottom crankshaft seal ring broken, or not sealing properly (90 HP).

JOHNSON MOTORS
Robert Compton
Administrative Assistant
Original Johnson engine photograph showing battery positive and negative cables, caution band, starter solenoid, starter cable, and torque terminal nut labels