Johnson Service Bulletin SB-1030 - Disconnecting Battery Cables from Engine

Issued September 22, 1964. Johnson cautioned dealers servicing 1965 alternator-equipped engines to disconnect the battery before removing engine battery cables, to avoid electrical arcing and damage to cable insulation.

Johnson Motors Service Bulletin gray letterhead

September 22, 1964

SUBJECT:  DISCONNECTING BATTERY CABLES FROM ENGINE.

APPLIES TO:  All 1965 Model, Alternator-Equipped Engines.

Due to elimination of the junction box, the positive and negative battery cables now run directly from the battery to the engine on 1965 model, alternator-equipped engines. Because of this hook-up, dealers must exercise caution when disconnecting or connecting battery cables at the engine.

Keep in mind that whenever the battery is connected, the positive cable is "hot". Any accidental touching to ground of this cable or of the wrench used to loosen the solenoid-terminal nut during cable removal would result in electrical arcing and possible cable-insulation burning if the battery were connected. Therefore, always disconnect the battery first before removing battery cables from the engine.

When attaching battery cables to the engine, always connect the battery after the cables are secured to the engine.

A white plastic cautioning band will be found assembled over the starter-solenoid end of the positive battery cable to serve as a reminder to this caution. See illustration on reverse side of this bulletin.

Sincerely,

JOHNSON MOTORS

Robert Compton
Administrative Assistant

RC/ll

NOTE: Post on V4-75 HP & VM-90 HP indexes under "ELECTRICAL".

Archive note

The original bulletin refers to an illustration on its reverse side. The supplied scan contains only the front page; the missing illustration has not been reconstructed.