Johnson Service Bulletin SB-1041

February 1965. Johnson explained how to distinguish the two high-speed tube and body assemblies fitted to 1964 V4M 90 HP carburetors. Using the wrong screw can create an air or fuel leak.

Johnson Motors Service Bulletin letterhead

February, 1965

SUBJECT:   90 HP CARBURETOR HIGH SPEED TUBE & BODY

ON ENGINES:  1964 MODEL - V4M

The 1964 90 HP carburetors have two different appearing high speed tube and body assemblies.

One high speed tube and body has a machined recess (figure 1 as shown in illustration), the other body assembly (figure 2) does not have a machined recess.

Factory comparison showing screws A and B and carburetor high speed tube and body assemblies 1 and 2

When servicing the 1964 90 HP carburetors, take note of which high speed tube and body has been used.  Be sure to use one short screw (figure B) in the body assembly, which has the machined recess, as the slightly longer screw (figure A) used in the body assembly will bottom itself and only appear to be tight.  This could cause a fuel or air leak up into the main high speed nozzle.

JOHNSON MOTORS

N. Peter Hansen
Administrative Assistant

NPH:rs

NOTE:  Post on your VM-90 HP index under "Carburetor".