Johnson Service Bulletin SB-1046 - Swivel Bracket Lubrication

March 1965. Factory maintenance instructions for lubricating the swivel bracket on 18 HP FD-17B, FD-18E, and FD-19D engines to prevent corrosion and malfunction.

Johnson Motors gray service bulletin letterhead
SB-#1046
March, 1965
SUBJECT: SWIVEL BRACKET LUBRICATION
ON ENGINES: 18 HP FD-17B, 18E, & 19D
The necessity of sufficiently lubricating the swivel bracket of the subject 18 H.P., FD engines can not be overemphasized. Parti- cularly when these engines are used in salt water, improper lubri- cation may result in corrosion and subsequent malfunction.
Proper lubrication of the swivel bracket can be accomplished by injecting OMC Type "A" Lubricant, via a grease gun, into the lower grease fitting on the swivel bracket until the grease begins to escape out the top of the swivel bracket around the pilot shaft.
It is absolutely necessary that the grease be injected until it does escape out the top of the swivel bracket in order to be sure of adequate internal lubrication.
The recommended frequency of lubrication, in normal salt water ser- vice, is every 30 days. However, local operating conditions, or severity of service may dictate more frequent lubrication.
Always use OMC Type "A" Lubricant in this preventive maintenance procedure.
JOHNSON MOTORS N. Peter Hansen Administrative Assistant
NPH:rs
NOTE: Post on your FD index under "Lower Unit."