Johnson Service Bulletin SB-1050 - Coil 580243

April 1965. Factory explanation of positive and negative coil polarity in V4 magneto ignition systems and the correct Stevens Magneto Analyzer testing procedure.

Johnson Motors gray service bulletin letterhead
SB-#1050
April, 1965
SUBJECT: COIL 580243
ON ENGINES: ALL V4 ENGINES EQUIPPED WITH MAGNETO IGNITION.
Our Quality Control Department has notified us that a good percentage of the 580243 Coils, that have been returned by our dealers under the Warranty Replacement Parts program, have been found to be perfectly serviceable. On checking into the reasons for warranty requests being sent in on these coils, we have found that dealers are condem- ing and requesting warranty on certain 580243 Coils simply on the basis of a polarity check. We have found that if a dealer finds a 580243 Coil with negative polarity, he will consider the coil serviceable provided, of course, that it passes all other tests. On the otherhand, we have discovered that some dealers are scrap- ing or requesting warranty replacement of 580243 Coils that are found to have positive polarity and are perfectly all right in every other respect.
The fact of the matter is, that THE POLARITY OF THE 580243 COIL CAN BE EITHER POSITIVE OR NEGATIVE. This is true because of the design of the magneto in which the 580243 Coil is used. This magneto creates two positive sparks and two negative sparks, and the only effect that coil polarity has is to determine which two cylinders will have positive sparks and which two cylinders will have negative sparks.
The fact that two of the sparks created by this magneto have posi- tive polarity, is not at all detrimental to engine operation, even- though 20 to 40% more voltage is required of the coil to produce positive sparks as opposed to negative sparks. The reason for the unique design of the V4 magneto was to keep the design less complex.
A new spark plug requires something in the range of 5 KV (5,000 volts) to fire it and will increase up to as high as 12 KV after considerable use. All of our magnetos put out well in excess of this even under the slow speed conditions of hand or electric cranking. For example, the V4 magneto at 300 RPM electric crank- ing speed puts out 16 KV minimum so that it will fire all plugs even if they are well used. When the engine is run at high speed, the available voltage output is in excess of 20 KV. When the V4 magneto was originally designed, a close study was made of the fact that two cylinders had a positive spark and two negative, and nothing detrimental could be found.
PAGE 2 SERVICE BULLETIN SB-#1050
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086
When testing a 580243 Coil on the Stevens Magneto Analyzer, a good coil of negative polarity will cause the meter pointer to come to rest in the green range of the red and green band marked 'Coil Test,' provided that the A-B switch is in the "B" position and that the Coil Index has been properly set at twenty-three (23).
A good 580243 Coil of positive polarity will cause the meter pointer to go all the way off the right hand end of the scale if the A-B switch is in the "B" position, and the Coil Index has been properly set at twenty-three (23). If, when testing a 580243 Coil, and the meter pointer goes completely off the right hand side of the meter, chances are you simply have a coil of positive polarity. Merely flipping the A-B switch to the "A" position and retesting the coil will enable you to determine whether it is good or bad.
JOHNSON MOTORS N. Peter Hansen Administrative Assistant
NPH:rs
NOTE: Post on your V4 50 and 75 HP Indexes and also on your VX 60 HP Index, under "Ignition."