Johnson Service Bulletin SB-1054 - Radio Noise Suppression Kit Modifications

June 1965. Factory corrections for binding high-tension leads and distributor interference on 75 and 90 HP alternator outboards and 90 HP stern drives.

Johnson Motors gray service bulletin header
SB-#1054
June, 1965
SUBJECT: RADIO NOISE SUPPRESSION KIT MODIFICATIONS
MODELS: 75 & 90 HP ALTERNATOR OUTBOARD AND 90 HP STERN DRIVES
Reports from the field have indicated that in certain cases a bind- ing condition exists when the throttle is returned to the idle po- sition on subject engines equipped with radio noise suppression kits. Any dealers who have received complaints of this nature should make the following corrections:
1. Remove and discard the tape securing the four high-tension leads together just behind the distributor.
2. Remove the plastic covering on the distributor to coil and the distributor to spark plug high tension leads. Use care in this operation to avoid cutting through the sheathing on high tension leads.
Original Johnson factory photograph sb-1054-figure-1.jpg
Figure 1
PAGE 2 SERVICE BULLETIN SB-#1054
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086
3. Retape the leads as shown in Figure 1. A plastic electrical tape is good for this purpose.
4. If, after the suppression kit is installed, an interference is found to exist between the coil clamp and the distributor cap cover preventing full movement of the distributor, the foot of the coil clamp may be cut off as shown in Figure 2.
Original Johnson factory photograph sb-1054-figure-2.jpg
Figure 2
JOHNSON MOTORS N. Peter Hansen Administrative Assistant
NOTE: Post on your V4, 75 HP and V4M, 90 HP Indexes under the heading of "Electrical."
NPH:rs