Johnson Service Bulletin SB-1061 - Crimped Ignition Lead Connection

Issued July 1965, this Johnson Motors service bulletin describes a concealed ignition-wire connection that can interrupt current to the positive coil terminal on battery ignition models.

Johnson Motors Service Bulletin letterhead
July, 1965

SUBJECT:  CRIMPED IGNITION LEAD CONNECTION

If the situation should arise where a battery ignition engine will not start and preliminary diagnosis reveals a no-current condition at the positive coil terminal, there is one connection in the red striped white ignition wire that certainly should not be overlooked as a possible cause of this difficulty.  This connection is located in the instrument cable assembly, just to the rear of where the battery end of the battery cables emerge from the heavy rubber insulation on the instrument cable assembly.  (See Figure 1)

If this heavy rubber insulation is slid back, as shown in Figure 1, the insulating tape over this crimped connection can be seen.  If the tape is removed, the connection can be checked and any necessary repairs can easily be made.  (Figure 2)

It is imperative that this connection be properly insulated after it has been checked or repairs have been made.  Plastic insulating electrical tape is adequate for this purpose.

Figure 1, instrument cable assembly showing tape-wrapped crimped connection
Figure 1
Figure 2, exposed crimped ignition lead connection
Figure 2

JOHNSON MOTORS

N. Peter Hansen

Administrative Assistant

NOTE:  Post on your V4, 75 HP and V4M, 90 HP Indexes under the heading "Electrical."