Johnson Service Bulletin SB-1062 - Heat Exchanger Inlet Cover No. 312326

July 1965. Johnson recommended an inlet cover for 1965 alternator-equipped two-cycle outboard engines to protect the heat exchanger inlet and voltage regulator.

Johnson Motors Service Bulletin letterhead

July, 1965

SUBJECT: HEAT EXCHANGER INLET COVER NO. 312326

MODELS: 1965 ALTERNATOR EQUIPPED OUTBOARD ENGINES

Factory diagram showing outer exhaust cover and heat exchanger inlet cover location

As you may have noticed, a heat exchanger inlet cover is now being used on all alternator equipped two-cycle engines. The purpose of this inlet cover is twofold:
1. It will deter the customer from plugging the heat exchanger inlet, and 2. It will eliminate the possibility of damage to the voltage regulator should the heat exchanger fail.

We recommend that you install an inlet cover whenever you have one of the subject models in your shop for service. Installation is easily accomplished by removing one bolt from the outer exhaust cover and securing the inlet cover beneath this bolt, see illustration.

JOHNSON MOTORS

N. Peter Hansen

Administrative Assistant

NOTE: Post on your V4A, 75 HP and V4M 90 HP Indexes under the heading of "Miscellaneous".

NPH:rs