Johnson Service Bulletin SB-1066 - New Replacement Powerhead Assemblies

Issued September 1965, this Johnson Motors bulletin explains the unusually high initial cranking resistance sometimes encountered with replacement powerheads for outboard motors rated 33 horsepower and above.

Johnson Motors Service Bulletin letterhead

September, 1965 SB-#1066

SUBJECT:  NEW REPLACEMENT POWERHEAD ASSEMBLIES

ON MODELS:  33 H.P. AND ABOVE

Occasionally, reports from the field come to us about the amount of torque required to crank over a new replacement powerhead for one of the above models. The reports indicate that this is only true the first time that the engine is cranked over after installation of the new powerhead. On succeeding starts, the engine cranks over with considerably less resistance.

More torque is required to crank the engine during the initial start because of a production-quality control change which eliminates the possibility of any "extra" needle bearings finding their way into the engine during assembly.

What this change amounts to is the substitution of a highly oil soluble wax strip in place of the Houghton's grease which was formerly used to hold the connecting rod needle bearings in place during assembly.

In normal production, this strip becomes rather soft after the engine passes through the paint bake ovens and remains soft up to the time that the engines are tested and the wax is dissolved.

In the field, an engine in which a powerhead containing these wax strips has been used, seldom passes through a bake oven or receives any other treatment which would tend to soften the bearing wax. Therefore, these engines are found to be "stiff" and require increased torque to crank them over during their initial start.

If kerosene or fuel mixture is squirted into the crankcase and onto the crankpin ends of the connecting rods, it will sufficiently soften the bearing wax in approximately three hours so that no more than normal cranking torque requirements are encountered when these powerheads are initially started.

JOHNSON MOTORS

N. Peter Hansen

Administrative Assistant

NOTE:  Post on your RD, RX, RK, VM, VX and V4 indexes under the heading of "Powerhead".

NPH:rs