Johnson Motors Service Bulletin factory letterhead
October, 1965SB-#1067

SUBJECT:   INDEXED QUADRANT SETTING - AUTOMATIC CHOKE

ON MODELS:   V4ML-12 100 HORSEPOWER MODELS

Our Engineering Department has advised that the automatic choke setting on those subject engines using carburetors marked with a single letter "H" on the automatic choke cover assembly is approximately 15° or three index quadrant notches too lean. The ONLY influence that this improper setting can possibly have on the engine is that when the engine starts, the warm up would be too lean.

The necessary adjustment should be made as follows:

  1. Before disturbing the original factory setting, scribe a mark along the Rich (R) side of the indexed quadrant. This line will serve as a convenient reference to the original setting.
  2. Loosen screw "A" (Figure 1) and adjust the quadrant three notches Richer (see Figure 2).
Figure 1: original indexed quadrant and screw A on automatic choke
Figure 1
Figure 2: indexed quadrant adjusted three notches richer
Figure 2
PAGE 2         SERVICE BULLETINJOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086

3. Tighten screw "A" (figure 1), being careful that the quadrant does not move while you do so.

REMEMBER:   This information applies ONLY to Carburetors marked with the SINGLE letter "H" on top of the Automatic Choke Cover Assembly.

JOHNSON MOTORS

N. Peter Hansen

Administrative Assistant

NPH:rs

NOTE:   This bulletin is to be Posted on your V4ML 100 H.P. Index.

Historical service reference

Models: V4ML-12, 100 H.P. Application: Carburetors marked with a single letter H on the automatic choke cover. Adjustment: Three index quadrant notches richer (approximately 15°).

This archived document reproduces the factory's 1965 service instructions for historical reference.