Johnson Service Bulletin SB-1072 - Overheating (October 1965)

This 1965 factory bulletin explains an overheating condition affecting V4ML-12 100 H.P. engines, caused by poor sealing at the return water tube and water pump housing.

Johnson Motors Service Bulletin factory letterhead

October, 1965

SUBJECT:   OVERHEATING

ON MODELS:  V4ML-12 100 H.P. ENGINES

In our production testing, we have found an easily overlooked cause for overheating of the subject engines.

Investigation of several subject engines that had overheated revealed that this condition was due to the return water tube from the powerhead not correctly entering the bushing and "O"-ring in the water pump housing. If this tube (the longer of the two copper tubes that fit into the water pump housing) enters the "O"-ring and bushing in the pump housing at a great enough angle, the "O"-ring will not seal around the return water tube, but instead will allow hot exhaust gases to leak into the intake side of the water pump.

With the gearcase removed, the sealing pattern of the "O"-ring can easily be seen on the periphery of the return water tube. If the sealing pattern of the "O"-ring is not completely around the tube, it could very easily be causing the engine to overheat. This condition can be corrected by reforming the return tube, as required, and applying a liberal coating of Sealer "1000" around the tube during assembly in the area where the "O"-ring seals on it.

JOHNSON MOTORS N. Peter Hansen Administrative Assistant

NPH:rs

Historical service reference

Bulletin: SB-1072 (October 1965) · Model: V4ML-12 · Engine: 100 H.P. Johnson outboard · Category: Lower Unit / Cooling System

Issue: Overheating caused by an improperly sealed return-water tube at the water pump housing bushing and O-ring. Factory remedy: Inspect the O-ring contact pattern, reform the tube if required, and apply Sealer "1000" around the tube at the sealing area during assembly.