Johnson Service Bulletin SB-1073 - Gearcase Housing

Issued in November 1965, this bulletin documents a revised water-intake slot arrangement for Johnson JH 3 HP and LD 5 HP outboard gearcases, together with the installation of water intake screen part number 312476. The original two-page factory bulletin is reproduced below with searchable text and its three illustrations.

Johnson Motors Service Bulletin letterhead

In the near future, a new style gearcase housing will be used in the production of 3 and 5 horsepower outboards. This new gear housing has an improved water intake slot design which will increase the volume of water entering the engine at maximum speeds. The two styles of gearcases may be easily identified by the shape of the water intake slots. See Figures 1 and 2.

Figure 1 previous gearcase with narrow vertical intake slots
Figure 1. Previous Gearcase
Figure 2 improved gearcase with horizontal water intake slots
Figure 2. Improved Gearcase
PAGE 2SERVICE BULLETIN SB-#1073
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
Figure 3 water intake screen showing where to apply pressure
Figure 3. Water Intake Screen

It will also be noted that a screen assembly, part number 312476, has been added to prevent the entrance of foreign material. Should it become necessary to replace either the gearcase assembly or the gear housing, the new screen assembly will be factory installed. If however, the screen assembly should become damaged or lost, a new screen may be installed as follows:

1. With the gearcase removed from the engine, insert the water intake screen into the cavity immediately to the rear of the driveshaft opening. Note that the shape of the screen has been slightly compressed to ease installation.

2. Align the screen assembly outer edges with the water intake slots of the gear housing. With the screen in this position, use a screwdriver or similar tool and apply pressure at the point indicated in Figure 3 so that the outer edges of the screen are expanded and wedged in the water intake slots.

JOHNSON MOTORS

N. Peter Hansen
Administrative Assistant

NOTE: Post on your JH, 3 HP Index and on your LD, 5 HP Index under the heading "Lower Unit".

NPH:rs.