Johnson Service Bulletin SB-1079: Look-A-Like Replacement Parts

Issued in December 1965, this bulletin cautioned dealers that similar-looking adapter plates and gaskets for JH and JW engines could not always be mixed. Using the correct parts catalog for the engine model was essential to prevent cooling-water restrictions.

Johnson Motors Service Bulletin factory letterhead
December, 1965

SUBJECT:   LOOK-A-LIKE REPLACEMENT PARTS

ON MODELS:   JH & JW-19A thru 21E Engines

The photo used in this bulletin illustrates vividly the importance of using an engine's model number when selecting parts from your inventory of replacement parts or when ordering parts from your Parts Distributor.

Original factory comparison of cylinder and crankcase assemblies, adapter plates and gaskets for JH-19A through 20B and JH-21E models

Although the members of the respective pairs of parts look alike, they contain important differences, which, if they were to be used in the wrong application, could result in extensive damage. For example: Adapter Plate, P/N 205574, and Gasket, P/N 312198, could be used with either of the cylinder and crankcase assemblies shown - PROVIDED that they are used together, - but Adapter Plate P/N 310199, and Gasket 310276 could not be used in conjunction with the 381019 Cylinder and Crankcase Assembly because of the webs that have been added to this assembly. The use of the wrong adapter plate and/or gasket with this cylinder and crankcase assembly would prohibit circulation of the engine coolant.

PAGE 2SERVICE BULLETIN   SB-#1079
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086

The best way to avoid problems caused by the use of the wrong look-a-like parts is to use the correct parts catalog for the model engine needing replacement parts. In doing this, you can be assured of obtaining the correct parts.

JOHNSON MOTORS

N. Peter Hansen

N. Peter Hansen

Administrative Assistant

NPH:rs

NOTE:   Post on your JW-JH Index under the heading "Miscellaneous".

Parts mentioned in SB-1079

205574 and 312198 are the adapter plate and gasket identified as a usable matched pair with either illustrated assembly. 310199 and 310276 must not be used with cylinder and crankcase assembly 381019.