Johnson Service Bulletin SB-1080 - Gearcase Service Information
Issued December 1965 for V4ML-12 100 H.P. engines, this bulletin describes servicing the magnetic filters in the cutaway gearcase and correctly installing the oil deflector.
December, 1965
SUBJECT: GEARCASE SERVICE INFORMATION
ON MODELS: V4ML-12 100 HP ENGINES
The magnetic filters shown in the cutaway gearcase in Figure 1 are important items that should certainly not be overlooked whenever one of the gearcases in which they are used is down for service. These filters are actually magnets that are contained by springs which, in turn, are pressed into and held in place by the fore and aft gearcase cavities.
These filters can easily be removed with the aid of a short length (approximately 12") of inner remote control wire that has a sharp loop on the lower end, to engage the spring, and a gradual loop on the other to serve as a handle.
With such a wire hooked into the spring, it is an easy matter to pull the filter assemblies from the gearcase. Once the filters have been removed, they can be cleaned by washing them in a solvent or degreaser and then blowing them off with air pressure.
Figure 1
PAGE 2SERVICE BULLETIN SB-#1080
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086
Figure 2
Installation of the filter assemblies is accomplished by inserting the assembled magnets and springs in the respective cavity and pushing it in place, with the aid of a long screwdriver.
Another item that is of utmost importance, if proper lubrication is to be assured, is the oil deflector (Figures 1 & 2) which is located directly beneath the pinion shaft's upper roller bearing.
You will note, in Figure 2, that the oil deflector has two notches in it located 180° apart. These notches are to be lined up with the oil drain holes in the gearcase (Figure 2) whenever one of them is installed. This deflector is a press fit in the cavity and should be replaced if it is found to fit loosely.
JOHNSON MOTORS
N. Peter Hansen
Administrative Assistant
NPH:rs
NOTE: Post on your VM-100 HP Index under the heading "Lower Unit".
Historical reference
Factory bulletin SB-1080, December 1965. Figure 1 identifies the magnetic filters and oil deflector; Figure 2 illustrates the oil deflector and oil drain hole positioning. These historical instructions are reproduced for reference.