Johnson Service Bulletin SB-1082 Rev. 1

April 1, 1966 - Excessive Exhaust Housing Temperature. Johnson describes two cooling-system changes for FD(L)-16 through 20 engines: a wider thermostat housing cover groove and an improved water tube that sprays water inside the exhaust housing.

Johnson Motors Service Bulletin factory letterhead
April 1, 1966 SB-1082 Rev. 1
SUBJECT:  EXCESSIVE EXHAUST HOUSING TEMPERATURE
ON MODELS:  FD(L)-16 THRU 20
Factory sketch of thermostat housing cover 308327 showing widened cooling groove and dimensions 9/16 and 5/32 centered

Two changes have recently been processed that lower the exhaust housing temperature of the subject engines, thereby increasing rubber mount and paint life.

One change amounts to widening a groove in the 308327 Thermostat Housing Cover. (See Sketch). This effectively increases the flow of cooling water through the engine, thereby

providing lower exhaust housing temperatures.

The other change involves a hole that has been drilled in the water tube, providing a spray of water on the inside of the exhaust housing in the area of the rubber mount, further lowering the Exhaust Housing Temperature.

PAGE 2 SERVICE BULLETIN SB-1082JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086

When you service any of the subject FD(L) models that show indications of excessive exhaust housing temperatures, the condition can be eliminated if (1) the later type cover is installed (or the existing cover is modified to the above conformation), and (2) an improved water tube, part number 303917 for model FD-16 thru 20 engines, or part number 304037 for model FDL-16 thru 20 engines is installed.

Both of these modifications must be effected if this condition is to be cleared up.

JOHNSON MOTORS N. Peter Hansen Administrative Assistant
NOTE: Post on your FD Index under the heading "Lower Unit."
Destroy SB-1082 dated March 1, 1966 and remove it from your Index.

NPH:rs

Parts and historical reference

308327 - Thermostat housing cover; widened groove increases cooling-water flow.
303917 - Improved water tube for FD-16 through FD-20.
304037 - Improved water tube for FDL-16 through FDL-20.

Both modifications are required to correct the overheating condition described in this bulletin. This April 1, 1966 revision supersedes the March 1, 1966 edition of SB-1082.