Johnson Service Bulletin SB-1084

March 1, 1966: Modification of Carburetor Float Adjusting Tool 380546. Johnson describes a modification allowing the existing float-adjustment tool to check float drop on V4ML-12 carburetors fitted with a limiting tab. The historical bulletin is reproduced below.

Johnson Motors Service Bulletin letterhead

March 1, 1966

SUBJECT:  MODIFICATION OF CARBURETOR FLOAT ADJUSTING TOOL 380546

Figure 1, float limiting tab, four times size
Figure 1

A simple modification to the subject tool will enable it to become even more useful than it is at present. If the following modification is made, it will be possible to use the 380546 Carburetor Float Adjusting Tool to measure the amount of float drop on V4ML-12 engines employing carburetor floats with a float drop limiting tab as shown in Figure 1.

A very easy procedure for making this modification is as follows:

  1. With a black marking pen, darken the end of the 380546 Tool as shown in Figure 2. This will allow you to see the marks that you will scratch on the tool.
  2. With the aid of a scale, a small square, and a sharp scribe, ACCURATELY scribe narrow lines on the tool that correspond with the dimensions for the marks on the blackened portion of the tool in Fig. 2.
Figure 2, marked tool with precise machining dimensions
Figure 2
PAGE 2SERVICE BULLETIN SB-#1084
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086
Figure 3, completed tool modification dimensions
Figure 3
Figure 4, tool placed against carburetor float bowl
Figure 4
  1. With a hacksaw, cut along the lines layed out on the tool in step 2 above. THE ACCURACY WITH WHICH YOU DO THIS IS EXTREMELY IMPORTANT!
  2. Use a fine file to remove any burrs left after cutting the tool.
  3. The modified tool should have the dimensions shown in Figure 3.

The modified 380546 Tool can now be used to measure the amount of float drop in V4ML-12 engines. To do this, hold the float bowl in an upright position as shown in Figure 4, and insert the tool as shown. The lower edge of the float will just be even with the bottom edge of the 1/32" notch in the float adjusting tool when the float drop limiting tab is properly adjusted.

If the limiting tab is not adjusted properly, bend it in the direction required to obtain the proper amount of float drop.

JOHNSON MOTORS
N. Peter Hansen
Administrative Assistant

Historical reference

Tool part number: 380546. The factory illustrations preserve the precise machining dimensions and should be consulted when interpreting this historical modification procedure.