Johnson Service Bulletin SB-1089 - Overheating

Issued April 1, 1966, this bulletin describes a water pump impeller housing improvement for Johnson V4ML-12 100 HP outboard engines, particularly where saltwater corrosion is present.

Johnson Motors Service Bulletin letterhead

April 1, 1966 SB-1089

SUBJECT:OVERHEATING
ON MODELS:V4ML-12, 100 HP ENGINES

If evidence of overheating has been encountered with one of the subject engines, the water pump impeller housing should not be overlooked as a possible cause of this difficulty.

Particularly in salt water areas, where electrolysis and corrosion are prevalent, all 380969 Impeller Housings (Figure 1) that are found in the subject engines should be removed and replaced with the improved 381436 Impeller Housing and Grommet Assembly shown in Figure 2. The grommets incorporated in the 381436 assembly provide a more effective seal where the water tubes enter the impeller housing and eliminate any possibility of hot exhaust gases entering the cooling system.

JOHNSON MOTORS
N. Peter Hansen
Administrative Assistant

NOTE: Post on your V4M-100 HP Index under the heading "Lower Unit."

NPH:rs

Figure 1 - Original 380969 impeller housing
Figure 1
Figure 2 - Improved 381436 impeller housing and grommet assembly
Figure 2

Parts referenced

380969 - Original impeller housing (Figure 1).

381436 - Improved impeller housing and grommet assembly (Figure 2).