Johnson Service Bulletin SB-1090 - Power Tilt Installation

Issued April 22, 1966, this bulletin describes the improved reverse lock latch release assembly for 100 H.P. V4ML-12 outboard engines. It identifies assembly 379306 and compares the improved design with the earlier release assembly.

Johnson Motors Service Bulletin gray letterhead
April 22, 1966
SUBJECT: POWER TILT INSTALLATION
ON MODELS: 100 HP V4ML-12 ENGINES
Due to the increased thrust available from the subject engines, heavier reverse lock springs are used than what had been used on previous V-4 engines.
Therefore, when installing a power tilt assembly on a 100 HP engine, it is imperative that the correct reverse lock release assembly be used.
An improved latch release assembly, part number 379306, illustrated in Figure one (1), has a larger (3/8" dia.) piston than the pre- vious release assembly (Figure 2) and can exert the additional pressure necessary to release the heavier lock springs.
Figure 1. Improved reverse lock latch release assembly, exploded factory photograph
In addition, this improved latch release assembly has the "O"-ring seal relocated to provide addi- tional corrosion resistance for the piston.
When transferring early model power tilt units to 100 HP Models, be sure they contain the 379306 re- verse lock latch release assembly illustrated in Figure one (1). Installation of the improved latch assembly is quite easily accomp- lished as attachment fittings are common.
Figure 2. Previous reverse lock latch release assembly, exploded factory photograph
JOHNSON MOTORS N. Peter Hansen Administrative Assistant
NOTE: Post on your Miscellaneous Index under the heading "Acces- sories".

Historical parts reference

379306 - Improved reverse lock latch release assembly for the 100 H.P. V4ML-12 power tilt installation. The bulletin specifies a 3/8-inch piston and relocated O-ring seal.