Johnson Service Bulletin SB-1091 - Malfunctioning Solid State Regulators

Issued May 1, 1966, this two-page bulletin addresses excessive charging-system resistance and poor regulator grounding on selected Johnson V4 engines. The original mounting illustration and repair guidance are reproduced below.

Johnson Motors Service Bulletin letterhead
May 1, 1966SB-1091
SUBJECT:   MALFUNCTIONING SOLID STATE REGULATORS
ON MODELS:   V4AL-17 THRU 18; V4M(L)-11 & V4ML-12
Factory illustration showing paint-free regulator housing mounting bosses for good electrical ground

When difficulty with the subject voltage regulator is encountered on one of the above mentioned engines, excessive resistance in the charging circuit may well be the cause of the difficulty.

Loose connections at the ammeter, key switch, battery terminals, voltage regulator or anywhere else in the charging circuit results in excessive resistance which, in turn, causes high voltage output which can burn out light bulbs, radio equipment and, in an extremely short time, the voltage regulator itself.

Since the outside case of the subject solid state regulator serves as part of the ground circuit of the charging system, it is imperative that it make a very good electrical contact with the exhaust cover on which it is mounted. In particular, the bosses (See Illustration) on the exhaust cover to which the regulator is mounted must be free of paint in the area of contact with

PAGE 2SERVICE BULLETIN SB-1091
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

the regulator if a high resistance connection is to be avoided. If the bosses are covered with paint in this area, they should be scraped free of paint using a sharp knife so that a good ground connection between the regulator and engine is assured.

JOHNSON MOTORS

N. Peter Hansen
Administrative Assistant
NOTE:   Post on your V4A-75 HP Index, V4A-80 HP Index,
       V4M-90 HP Index and V4M-100 HP Index under
       the heading "Electrical".

NPH:rs

Historical service reference

SB-1091: Malfunctioning solid state voltage regulators, May 1, 1966. Applies to Johnson V4AL-17 through V4AL-18, V4M(L)-11, and V4ML-12 engines. Inspect loose charging-circuit connections and ensure the regulator housing mounting bosses are free of paint for reliable electrical grounding.

No replacement part numbers are specified in this bulletin.