Johnson Service Bulletin SB-1092: Erratic Idling

Issued May 1, 1966, this bulletin describes checking the heat exchanger on outboards fitted with hot-air-activated automatic chokes. Carbon inside the choke housing may indicate a ruptured heat exchanger. The original factory bulletin is reproduced below in searchable text.

Johnson Motors Service Bulletin factory letterhead

May 1, 1966

SUBJECT:ERRATIC IDLING
ON MODELS:ALL ENGINES EQUIPPED WITH HOT AIR ACTIVATED
AUTOMATIC CHOKES

In cases where poor idling is a problem with these models, examine the heat exchanger for breakage and check to see that the heat exchanger is functioning properly.

This is easily done by removing the choke housing cover and examining for carbon deposits. Carbon inside the housing indicates that the heat exchanger has ruptured, is allowing exhaust gases to enter the engine and must be replaced.

When examining heat exchangers on engines that are being serviced, it is not necessary to replace exchangers that have the tops buckled slightly. Fractures may occasionally occur, however, on the underside of the heat exchanger near the nipples.

JOHNSON MOTORS
N. Peter Hansen
N. Peter Hansen
Administrative Assistant

NPH:rs

NOTE: Post on your RD and RK-40 HP Indexes and on your V4 and V4M Indexes under the heading "Carburetion".

Historical reference

SB-1092 applies to engines equipped with hot-air-activated automatic chokes. The factory directs filing under “Carburetion” in the RD, RK-40 HP, V4 and V4M indexes.