Johnson Service Bulletin SB-1094 - Blown Fuse - Power Tilt

Issued June 3, 1966, this bulletin explains a power tilt wiring change for Johnson V4ML-12 engines to prevent the 20-amp ignition circuit fuse from blowing when the power tilt operates while the engine is running.

Johnson Motors Service Bulletin gray factory letterhead

June 3, 1966

SUBJECT:BLOWN FUSE - POWER TILT
ON MODEL:V4ML-12

Under certain conditions, the 20 amp fuse between the ammeter and the key switch has been known to blow out when the power tilt is operated while the engine is running.

When the engine is running, the amperage load on this 20 amp fuse includes the ignition coil, alternator field and if engaged in gear, the electromagnetic coil. Some accessories may also be operating through this fuse. The additional amperage required by the power tilt, under the above conditions, may be too great for the 20 amp fuse, blowing same.

To eliminate this situation, we are now advising that the power tilt lead, which includes a 20 amp fuse holder, be connected to the "BAT" terminal on the ammeter, instead of the "BAT" terminal on the ignition switch. This procedure is now a part of the latest instruction sheets enclosed with the power tilt kits.

NOTE:  BE SURE THAT THE TILT SWITCH LEAD INCORPORATES
      A 20 AMP FUSE.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK:rs

NOTE:  Post on your VM-100 Index under the heading "Electrical" and on your Miscellaneous Index under the heading "Accessories".

Historical service reference

Models: V4ML-12. Subject: power tilt electrical connection and 20-amp fuse protection. The factory specifies the ammeter BAT terminal for the separately fused power tilt lead, rather than the ignition-switch BAT terminal.