Johnson Service Bulletin SB-1103 - Overheating and Gasket Replacement
September 1966. Johnson outlined six checks for engine overheating and instructed dealers to replace cylinder head and exhaust cover gaskets after an overheating problem has been corrected.

September, 1966
Whenever problems of overheating are encountered on any engine, the normal recommended procedure is to check out the following possible causes:
- An inoperative water pump due to worn or faulty pump parts such as, (a) impellers, (b) housings, (c) pump plates, (d) grommets, (e) seals, etc.
- Clogged or obstructed water passages, hoses, intake screens, etc. due to:
- Corrosion - particularly in salt water areas.
- Metal flashing - a thin film of metal left in as a result of die casting.
- Other foreign matter or objects.
- Clogged water jackets and passages in cylinder blocks and heads. Look for the same causes as listed under 2a, b, and c - preceding.
- Inoperative thermostats, vernatherms or water pressure valves on all engines equipped with thermostatically controlled cooling systems.
- Faulty gaskets and water hose connections.
- REPLACE ALL AFFECTED COOLING SYSTEM GASKETS - ESPECIALLY CYLINDER HEAD AND EXHAUST COVER GASKETS.
Step #6 is strongly recommended because overheating tends to dry out the gaskets and causes them to shrink. This is especially true of the cylinder head and exhaust cover gaskets. Their basic functions are to provide a tight seal between the cylinder head and exhaust cover and cylinder block to confine water to its respective passages, and seal combustion and exhaust pressures inside their respective areas. Since combustion pressures are
very high, the head gasket may no longer efficiently perform its intended function and consequently allow exhaust gases to enter the cooling system; thus intensifying the heating problem. While the pressure in the exhaust manifold area is not as high, consideration must be given here also.
Always replace cylinder head and exhaust cover gaskets on any engines which have overheated. Do this after having first checked all other possible causes, or after being certain the cause of overheating has definitely been corrected. Otherwise, the new head and exhaust cover gaskets may also dry, shrink and again allow exhaust gases to enter the cooling system.
Repeat - As your final corrective operation, ALWAYS replace cylinder head and exhaust cover gaskets on all engines which have overheated.
JOHNSON MOTORS
Carl Klawonn
Administrative Assistant
CK/rkm
NOTE: Post on all Indexes under the heading "Powerhead".
Destroy SB-#796 dated August 26, 1960.
Related service bulletins
Supersedes: SB-796 (August 26, 1960). The factory instructed dealers to destroy the earlier bulletin and file SB-1103 under "Powerhead".