Johnson Service Bulletin SB-1108 - Securing Vibration Dampener Brackets

Issued November 1966, this bulletin follows SB-1107 and specifies stronger mounting hardware for the vibration dampener brackets on Johnson MQ-10S through MQ-12A 9½ HP outboards.

Johnson Motors Service Bulletin gray factory letterhead

SB-1108         November, 1966

SUBJECT:  SECURING VIBRATION DAMPENER BRACKETS

ON MODELS:  MQ-10S THRU 12A, 9½ H.P.

Subsequent to the issuance of SB-#1107, announcing the availability of Vibration Dampener Kits, we discovered that the four truss head screws which mount the Vibration Dampener brackets to the motor covers, are not withstanding vibration, and are coming loose.

We are recommending that you use 1/4 - 20 x 5/8" hex head screws, our Part No. 304027, with lockwashers No. 302290, run into the bracket from the back side. Elastic stop nuts, No. 313022 would be used on the front of the motor covers. (See drawing below).

This modification affords a more substantial installation and will be made on all Vibration Dampener Kits in stock, and in process.

JOHNSON MOTORS Carl Klawonn Administrative Assistant

CK:rs

NOTE:  Post on your MQ-9½ H.P. Index under the heading "Miscellaneous"

Original factory drawing comparing truss-head bracket mounting with hex-head screw, lockwasher and elastic stop nut arrangement

Related bulletins and parts

This bulletin follows SB-1107 - Vibration Dampener Kits. Mounting hardware: 304027 hex-head screw, 302290 lockwasher, and 313022 elastic stop nut.