Johnson Service Bulletin SB-1109 - Power Tilt Installation on 100 H.P. Outboard Motors

September 1966. Johnson Motors introduced a revised reverse lock link for 1966 V4ML-12 power tilt installations that failed to relatch when the motor was lowered.

Johnson Motors Service Bulletin factory letterhead

September, 1966

SUBJECT:   POWER TILT INSTALLATION ON 100 H.P. OUTBOARD MOTORS

ON MODELS:  100 H.P., V4ML-12 ENGINES

Some operators of the Power Tilt are finding, when lowering the 100 horsepower outboard motor to full down position, the REVERSE LOCK mechanism is not relatching. To correct this situation, a new reverse lock link is being supplied with each Power Tilt Kit. See drawing below:

Factory photograph comparing old and new reverse lock links
OldNew

If the Kit you receive from your parts distributor does not have the new part in it, or you have an existing installation needing the new part, you can procure one no-charge by contacting Johnson Motors, Service Department, Waukegan, Illinois 60085. The part is 381991, Reverse Lock Link.

This applies only to the 1966 100 horsepower outboard motors. It will not be necessary to install the new link on 1967 100 horsepower models due to a design change on the stern mounting brackets of the motor.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK:rs

NOTE:   Post on your V4M-100 HP Index under the heading "Miscellaneous".