Johnson Service Bulletin SB-1120 - Generator Bracket

Issued February 1967, this bulletin identifies generator bracket mounting hardware that should be checked for proper torque to avoid premature bracket failure on certain 40 HP Johnson outboards and accessory generator installations.

Johnson Motors Service Bulletin header

February, 1967

SUBJECT:  Generator Bracket - Part #305679

ON MODELS:  RK(L)-24 thru 29 - 40 H.P. and
            Accessory Generator Kit

If the mounting screws and nuts related to the subject generator bracket are not tightened to the proper torque specifications, it is quite conceivable that premature failure of the #305679 Generator Mounting Bracket will occur.

We suggest you refer to the illustration on the reverse side and check the tightness of the following whenever one of the above motors, or a motor equipped with an accessory generator comes into your shop for service:

A.306375 Nut (2)- 5-7 ft./lbs.
B.308355 Nut (3)- 5-7 ft./lbs.
C.306419 Screw (1)- 5-7 ft./lbs.
JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK/rkm

(Over)

Factory generator mounting photograph showing the A, B, and C fasteners and 5 to 7 foot-pound torque instructions

Parts and service reference

Generator mounting bracket 305679; mounting nuts 306375 (two) and 308355 (three); mounting screw 306419 (one). Each is specified at 5-7 ft-lb. The second page retains the original annotated factory photograph for locating these fasteners.