Johnson SB-1123 (March 1967). Factory instructions for rerouting the shift cable and securing the outer exhaust cover and rear lower motor cover on V4ML-12 100 H.P. engines.
Johnson Motors Service Bulletin letterhead
March, 1967

SUBJECT:   RE-ROUTING OF SHIFT CABLE AND INSTALLATION
            OF OUTER EXHAUST COVER AND REAR LOWER MOTOR COVER.

ON MODEL:  V4ML-12, 100 H.P.

Whenever one of the above motors is in your shop for service, we recommend the following changes be made:

Re-routing of Shift Cable:

Remove the present clamp under the thermostat. Using a second #310442 Clamp, secure the shift cable as illustrated in Figure 1.

Figure 1 - shift cable and new clamp positions marked A and B

This positions the shift cable to eliminate the possibility of it being pinched between the exhaust housing and bumper assembly. (See Figure 2.)

Figure 2 - rerouted shift cable prevents pinching
PAGE 2SERVICE BULLETIN SB-1123
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

Installation of the Outer Exhaust Cover and
Rear Lower Motor Cover:

When installing these covers, use 12 pieces #313061 Hex Head Screws torqued to 8-10 ft/lbs, replacing the 12 - #312458 Phillips Fillister Head Screws. (See Figure 3.)

Figure 3 - torque wrench tightening cover screws to 8-10 foot-pounds

----- CAUTION -----

Referring to Figure 1, points A & B, be sure the two holes in the Front Lower Motor Cover are tapped deep enough to accept the #313061 Hex Head Screws.

The use of hex head screws torqued as specified reduces the possibility of the exhaust cover working loose in rough water.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK:rs

NOTE:  Post on your VM-100 H.P. Index under the heading "Lower Unit".

Historical parts reference: Clamp 310442; hex head screw 313061 (12 required, 8-10 ft-lbs); earlier Phillips fillister head screw 312458 (12 replaced). These numbers and specifications are reproduced from the original bulletin.