
April, 1967
SUBJECT: GEARCASE WHINE
ON MODELS: FD MODELS
All too often, we receive requests for warranty for repairs made to a motor to eliminate gearcase whine. Such repairs usually include crankshaft main bearing replacement in the powerhead and/or gears and bearing replacement in the gearcase.
Upon investigation of the supposedly "defective" parts, we find that many repairs were needless, and there being no defect in the parts replaced.
We have determined that an excessive amount of grease on the upper driveshaft spline creates a pneumatic action causing downward pressure on the pinion gear, thus the whine from the gearcase.
Whenever gearcase whine is apparent, we suggest inspection of the upper driveshaft spline for an excessive amount of grease. If such a condition is found, it might well be the cause of the whine, and needless, costly replacement of parts in the powerhead and/or gearcase might well be eliminated. To avoid such a condition, clean the driveshaft and crankshaft splines free of grease, and re-grease leaving one spline "dry". During reassembly, the trapped air can then easily escape and the pneumatic action will be eliminated.
Carl Klawonn
Administrative Assistant
CK/rkm
NOTE: Post on your FD Indexes under the heading "Lower Unit".
Please make the following correction to your 1967 Parts Reference Guide: Page 20 under the heading "Gearcase Complete", P/N 278773 should read "JW-10 thru 22, JWF-22 (less driveshaft and water pump)".