Johnson Service Bulletin SB-1135 - Current Coupler and Universal Tachometer

June 1967. Johnson Motors announced revised current coupler #381960 and provided installation guidance for the OMC universal tachometer #171741, including terminal configurations for different ignition systems.

Johnson Motors Service Bulletin gray factory letterhead

June, 1967 SB-#1135

SUBJECT:  OMC ACCESSORY INFORMATION - CURRENT COUPLER AND
           UNIVERSAL TACHOMETER

As you may have noted in the OMC Accessory Brochure, a new part number has been assigned to the Current Coupler.

Several changes had to be made to the #378849 Current Coupler to have one useable on the new 40 H.P. motors without junction boxes.

The new Current Coupler, P/N 381960, is useable on the following models:

RX-10 thru 12M

RXE-10C thru current model

RD-25D only

RDS-20 thru current model

RK-24 thru current model

VX-10S thru 12M

VXH-10S thru 12R

V4S-10 thru 18C

V4H-16A & 17S

Figure 1 - OMC universal tachometer face and mounting hardware
Figure 1

Illustrated in Figure 1 is the OMC Universal Tachometer Part No. 171741. We have had several reports of this tachometer failing, but upon inspection have found most of them to be without defect and feel the failures were due to improper installations.

Admittedly, the instructions can be easily misunderstood, especially the ones packed with the earlier tachometers. However, with a little study, correct installation can be achieved. Figure 2 illustrates

the four terminals on the back side of the tachometer which are used to change the internal circuitry for various applications. An example of this is for two cycle, four cylinder battery ignition engines, in which application all four terminals are connected, using the short piece of jumper wire included in the kit. For two cycle, two cylinder magneto engines, no external connections are required. (See Terminal Connector Chart)

PAGE 2 SERVICE BULLETIN
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

TERMINAL CONNECTOR CHART

MAGNETO IGNITION OUTBOARD MOTORS

2-Cycle
1-Cylinder
2-Cycle
2-Cylinder
2-Cycle
4-Cylinder
No terminal connection requiredNo terminal connection requiredC-2

BATTERY IGNITION OUTBOARD MOTORS

2-Cycle
2-Cylinder
2-Cycle
3-Cylinder
2-Cycle
4-Cylinder
2-Cycle
6-Cylinder
4-Cycle
4-Cylinder
No terminal connection requiredC-2-3C-2-3-4C-2-3C-2

BATTERY IGNITION
INBOARD, INBOARD-OUTBOARD, AUTO, TRUCK, INDUSTRIAL

2-Cycle
4-Cylinder
4-Cycle
2-Cylinder
4-Cycle
4-Cylinder
4-Cycle
6-Cylinder
4-Cycle
8-Cylinder
C-2-3-4No terminal connection requiredC-2C-2-3C-2-3-4
Figure 2 - Rear of universal tachometer showing numbered terminal connections and wiring
Figure 2

The Mounting Panel shown in Figure 1, is a relatively new accessory and is available through your Parts Distributor under P/N 171861. Consult your Master Parts Price Book and/or Supplement for current price and discount.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK/rkm

NOTE:   Post on your Miscellaneous Index under the heading "Accessories".

Historical reference

The terminal connector chart above is transcribed as searchable text. The original photographs show the tachometer face and rear terminal arrangement. Historical instructions should be checked against the correct equipment service manual before use.