Johnson Service Bulletin SB-1136 - Gearcase Information

Issued June 1967, this bulletin warns owners and mechanics of 35 and 40 H.P. Johnson outboards that two similar-looking impeller housing caps are not interchangeable. Incorrect substitution can interrupt cooling-water delivery at higher speeds.

Johnson Motors Service Bulletin factory letterhead

June, 1967

SUBJECT:   GEARCASE INFORMATION

ON MODELS:   RD-21 thru 29E - 35 & 40 H.P.
            RDS-20 thru 29E - 35 & 40 H.P.
            RK-24 thru 29E - 40 H.P.

Illustrated below are the Impeller Housing Caps as used on the above models. At a glance, you can plainly denote the major difference. However, we have had reports that the latter style P/N 312615 Cap has been used as a replacement on 1966 and earlier models in place of P/N 307954. These parts are not interchangeable.

Original factory comparison of impeller housing cap 307954 and cap 312615, showing water inlet and model applications

Using a #312615 in place of #307954, the water inlet hole is not used. The engine can cool satisfactorily at low R.P.M. or in a test tank due to the presence of water in the exhaust stack. However, this supply of water disappears as R.P.M. and boat speed increase, allowing exhaust to be drawn into the cooling system, quite conceivably causing extensive powerhead damage.

PAGE 2          SERVICE BULLETIN
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

It is important that you familiarize yourself with the new style gearcase as introduced on the 1967, RD and RDS models. These gearcases do not have the water intake plate on the port side, the water pick up being under the exhaust outlet behind the propeller. This redesign necessitated the new style Impeller Housing Cap with the additional hole for the inlet tubing.

When inventories are depleted of the old style service gearcases for 1958 through 1966, RD and RDS models, you will receive, under the same part number, the new style gearcase. Caution must be exercised when parts such as the Impeller Housing Cap need to be replaced. The new style service gearcases also have the Snap-Action Clutch Dog.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK/rkm

NOTE:   Post on your RD - 25, 30 & 35 H.P., and RD - 40 H.P.
       Indexes under the heading "Lower Unit".

Historical parts reference

307954 - Earlier impeller housing cap, shown for RD-21 through 28B, RDS-20 through 28B and RK-24 through 29E in the factory illustration. 312615 - Later cap with an additional water-inlet connection, shown for RD-29E and RDS-29E.

Important: These caps are not interchangeable. Match the cap to the gearcase's cooling-water inlet arrangement rather than assuming the same model family uses the same cap.

Browse other pre-1969 service bulletins