Johnson Service Bulletin SB-1139 - Tilt Assist Spring Safety Reminder

August 1967. Johnson Motors reminded dealers that the powerful tilt-assist spring fitted to 1958 and 1959 50 H.P. outboards could cause injury if released without the safety stern bracket latch. The bulletin describes the safety retrofit kit and caution plate.

Johnson Motors Service Bulletin gray factory letterhead

August, 1967

IMPORTANT REMINDER

SUBJECT:  TILT ASSIST SPRING - V4, V4S-10 & 11 - 50 H.P.

The 1958 and 1959 JOHNSON 50 H.P. models incorporated a heavy coil spring in the swivel bracket to provide easy tilting of the motor for beaching, propeller changing, etc.

The spring is extremely powerful and will practically tilt the motor by itself. The energy stored in the spring is very helpful when tilting the motor on the boat; however, without a safety device this energy can be dangerous if released with the motor off of the boat. The 1959 models were equipped with a safety latch on the starboard stern bracket, and 1958 models should all have been modified with a stern bracket kit. Without the safety device, accidental release of the tilt lock with the motor off the boat allows spring tension to snap the transom bracket upward and injury may result.

Stern bracket kits, P/N 377846, are still available no charge from the factory, and we strongly urge you to install them on any 50 H.P. models that do not have the safety latch. Send your request for this kit to the factory Service Department along with model and serial number of the engine on which it is to be installed.

Installation instructions are furnished with #377846 assembly which includes a claim form for labor reimbursement. The factory is no longer paying labor for installation of #377846 assembly. Therefore, disregard this segment of the instruction sheet.

Also be sure the caution plate decal located on the front of the swivel bracket is legible. If not, new ones are available from your Parts Distributor as follows:

Caution Plate - Part No. 305761 - $.10 each

JOHNSON MOTORS
Carl Klawonn
Administrative Assistant

CK/rkm

NOTE:  Post on your V-50 H.P. Index under the heading "Lower Unit."
      Destroy previous issue of this bulletin, SB-#977 dated September 19, 1963.

Related factory bulletin

SB-977 (September 19, 1963) - Previous issue. Johnson directed dealers to destroy the earlier bulletin when SB-1139 was issued. The link is retained for historical reference.

Historical safety notice: This is an archival reproduction, not a substitute for current safe-service procedures. The tilt-assist spring can store dangerous energy.