Johnson Service Bulletin SB-1146 (November 1967)

This factory bulletin describes repairing a broken cast-in crankcase drain nipple on certain 28 and 33 HP Johnson outboards. It specifies replacement parts, drilling and tapping tools, and a critical maximum drilling depth intended to protect the internal oil-drain metering hole.

Johnson Motors Service Bulletin letterhead

November, 1967 SB-1146

SUBJECT: REPAIRING BROKEN CRANKCASE DRAIN NIPPLES

ON MODELS: RX(L)-10 thru 12, 28 H.P.
RX(L), RXE(L)-13 thru 16, 33 H.P.

Replacement of the cylinder and crankcase assembly is often necessitated when the front motor mount breaks. When this mount breaks or otherwise lets loose, the powerhead drops and in many cases causes the crankcase drain nipple to be broken. As the nipple is cast in place, it cannot be replaced by simply screwing in another nipple.

If the following procedure is followed, an otherwise good crankcase and cylinder can be saved.

Repair Procedure: File the remains of the broken off nipple in the crankcase flat with surrounding aluminum surface. Drill a hole 1/2" deep through the hole already in the broken off section of the nipple using the prescribed drill.

CAUTION: Be extremely careful not to drill deeper than 1/2". To do so will destroy a small oil drain metering hole that is essential for proper engine performance. Because you will be drilling brass, the drill will have a tendency to "pull" into the hole as you drill. USE EXTREME CAUTION.

Thread the hole just drilled using the prescribed tap, after which be certain to remove all chips and burrs. Install one-#303638 Nipple and one-#303630 Washer. Sealer 1000 or Gasolia Varnish applied to the threads of the nipple prior to assembly will insure a leakproof seal.

PARTS REQUIRED:

1 - 303638 Nipple
1 - 303630 Washer

TOOLS REQUIRED:

#3 tap drill (decimal equivalent - .2130"; nearest fractional size - 7/32")

1/4-28 N.F. tap

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

Parts and service reference

303638 - replacement drain nipple; 303630 - washer. The factory specifies a No. 3 drill (.2130 inch, with 7/32 inch listed as the nearest fractional size), a 1/4-28 N.F. tap, and a maximum drilling depth of 1/2 inch.

Historical service information: This page reproduces a 1967 factory procedure. Assess current engine condition and applicable safety practices before attempting repairs.