Johnson Service Bulletin SB-1151 - Engine Failure Due to Marginal Cooling

Issued December 1967, this bulletin identifies two overlooked sources of exhaust gas intrusion into the cooling systems of Johnson 40 HP outboards: a hairline crack in the gearcase casting and an incorrectly installed water pickup tube grommet.

Johnson Motors Service Bulletin letterhead

December, 1967

SUBJECT: ENGINE FAILURE DUE TO MARGINAL COOLING

ON MODELS: RD, RDS-29E and 30D - 40 H.P.

Insufficient water volume and pressure, overheating and scored or seized powerhead . . .

This is all too often the cycle which leads to a disabled outboard. Repairing only one phase puts off a repeat failure for only a short time. Find the cause of failure, then make all the necessary repairs.

In many cases, replacement of the impeller and/or impeller housing and plate is all that is required to remedy an overheating problem and put the engine back in service. However, if a small opening exists whereby exhaust gases can enter the cooling system, it isn't long before the water pump loses its full efficiency and can no longer overcome the hot exhaust.

Such a condition has been found in some of the models listed above. A hair line crack has been found in the wall between the water pump area and exhaust discharge (Figure 1). Such an opening is oftentimes hard to locate, and is all it takes to ruin the efficiency of the cooling system.

Figure 1: gearcase water pump housing showing location of hairline crack
FIGURE 1 - NOTE HAIRLINE CRACK
PAGE 2    SERVICE BULLETIN SB-1151
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

We have also found a few cases where the grommet on the lower end of the water pick-up tube was installed in a "cocked" position. Figure 2 illustrates such an installation which could have provided another entrance of exhaust gases into the cooling system.

Figure 2: water pickup tube with grommet cocked during installation
FIGURE 2 - GROMMET COCKED DURING INSTALLATION

After the cause of overheating has been found and corrected, we recommend the cylinder head and exhaust cover gaskets be replaced. Overheating tends to dry out gaskets, causing them to shrink and lose their sealing qualities. This is especially true in the case of cylinder head and exhaust cover gaskets.

Although the cooling systems in these engines are adequate, the water pump and related parts must be closely watched to insure maximum operation.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK/rkm

NOTE: Post on your RD - 40 H.P. Index under the heading "Lower Unit".

Historical service reference

Inspect both the water pump casting and pickup tube grommet when diagnosing recurring overheating. The bulletin recommends renewing cylinder head and exhaust cover gaskets after correcting the underlying cooling fault.