Johnson Service Bulletin SB-1153 (February 1968)

Plugged Intake Screens and Consequent Overheating. Factory guidance for adding cooling-water inlets to affected Johnson 3 HP and 5 HP outboards.

Johnson Motors Service Bulletin letterhead

February, 1968

SUBJECT: PLUGGED INTAKE SCREENS AND CONSEQUENT OVERHEATING

ON MODELS: JH-19A thru 23A - 3 H.P.
     LD-10S thru 13M - 5 H.P.

To compensate for the subject condition, four holes have been added in the gearcase to provide additional water inlets for cooling at low boat speeds. These are necessary should the water intake screens get covered with leaves, weeds, etc.

Figure 1: gearcase showing four 3/32-inch cooling-water inlet holes and drill locations

Figure 1 illustrates the location of the four holes which are 3/32" diameter. They are located on the port side, adjacent to the die parting line. The bottom hole is 1-3/4" above the center of the propeller shaft, with the remaining holes 7/16" center to center. We recommend that all the above models be reworked according to the illustrated specifications. The holes will have to be drilled at a slight angle in order to clear the exhaust outlet. Drill the top hole first, then drill remaining holes at the same angle. Do not drill any deeper than is required to penetrate the outer wall.

As a reminder, whenever working on an engine that has experienced overheating, your final corrective operation should include replacement of cylinder head and exhaust cover gaskets.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK/rkm

NOTE: Post on your JW, JH - 3 H.P. and LD - 5 H.P. Indexes under the heading "Lower Unit".

Historical reference

Models: JH-19A through JH-23A (3 HP); LD-10S through LD-13M (5 HP). Subject: restricted water intakes, overheating, and supplemental gearcase cooling-water holes. Follow the factory figure for hole locations, spacing and drilling angle.