Johnson Service Bulletin SB-1154 - Breaker Point Spring Tension

Issued February 1968, this bulletin documents the 28 to 32 ounce breaker point opening tension required on certain 1968 Johnson C.D. ignition engines. It explains proper gauge alignment and cautions against excessive spring tension or opening the points too far during cleaning.

Johnson Motors Service Bulletin gray letterhead

February, 1968

SUBJECT:   BREAKER POINT SPRING TENSION

ON MODELS:  TR(L)-10 - 55 H.P.
            VH, VXH(L)-14 - 65 H.P.
            V4S, V4A(L)-20 - 85 H.P.

Diagram: direction of pull must be parallel with axis of breaker pointsFactory photo of tension gauge measuring breaker point spring tension, with 28-32 oz pull indicated

It has been determined that incorrect Breaker Point Spring Tension (under 28 oz.) on the subject 1968 C.D. Ignition Models can be the cause of a miss at the top end of the R.P.M. range (full throttle).

The points must be clean and require 28 to 32 oz. pull to open them, as illustrated. This setting is of absolute necessity as only one volt passes through the points. Excessive tension (over 32 oz.) will result in excessive wear of the cam follower.

SNAP-ON TOOLS GAUGE #MT-104 (as illustrated) or its equivalent is designed to test breaker point spring tension. Order gauge from your local Snap-On or regular supplier. DO NOT ORDER FROM THE FACTORY.

The gauge is to be used as illustrated. The tip of the instrument must be placed in line with the center of the points, on the rocker arm. The direction of pull must be along the line extending from the center of the points as illustrated.

PAGE 2 SERVICE BULLETIN SB-1154
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

CAUTION:  Excessive opening of the points to clean them will weaken spring tension. Always check breaker spring tension 28 to 32 oz. whenever it is necessary to clean, adjust or install points on 1968 55, 65 & 85 H.P. C.D. Ignition Engines.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK/rkm

NOTE:  Post on your VX - 60 H.P. and V4 - 80 H.P. Indexes under the heading "Ignition".

Historical reference

Snap-on MT-104 is the breaker point spring-tension gauge specified in the original bulletin. The factory instructs dealers to obtain it from a tool supplier, not Johnson Motors. All measurements and procedures above are reproduced as historical service information.