Johnson Service Bulletin SB-1164 - Bolt - Stern Bracket to Transom

Issued June 1968, this bulletin describes supplementary transom mounting bolts for Johnson 55, 65, 85 and 100 HP outboard motors, including the original hardware part numbers and prices.

Johnson Motors Service Bulletin letterhead

June, 1968

SUBJECT:BOLT - STERN BRACKET TO TRANSOM

ON MODELS:TR(L)-10, 55 H.P.
VX, VXH(L)-14, 65 H.P.
V4S, V4A(L)-20, 85 H.P.
V4TL-14, 100 H.P.
Factory illustration identifying stern brackets, bolts and transom

The special bolts, as illustrated, are designed to fasten 55, 65, 85 and 100 H.P. motors direct to the boat transom.

These bolts are standard equipment on the 100 H.P. models, but are optional for the same purpose on the 55, 65 and 85 H.P. motors.

We recommend that any boat operating under extreme usage be equipped with this added protection.

Once the desired motor mounting height is determined, secure the motor by bolting the stern brackets to the transom. Using the stern brackets as a guide, drill two 1/2" diameter holes through transom, pass bolts through from outside, and secure with washers and nuts.

Order these parts from your distributor under the following numbers.

BOLTPart No. 313672$2.00 each
WASHERPart No. 307238$.40 each
NUTPart No. 307407$.20 each
JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

Historical parts reference

313672 - transom mounting bolt; 307238 - washer; 307407 - nut. Prices shown above are the original 1968 factory prices, not current retail prices.