Factory lubrication instructions for the anti-reverse cut-off spring on Johnson distributor-equipped engines. Includes an important correction to the 1968 100 HP service manual.
June, 1968
SUBJECT: ANTI-REVERSE CUT OFF SPRING - LUBRICATION
OMC Type "D" Lubricant is to be used for lubrication of the reverse cut off spring part number 313743. Each time the distributor is serviced or disassembled, it is imperative that fresh lubricant be applied.
The reverse cut off spring is located on the crankshaft under the distributor base.
To lubricate the spring, refer to the diagram above and follow this procedure:
Remove the flywheel and alternator stator.
Lift distributor cap and remove the rotor and wave washer.
Remove the distributor base by disconnecting the necessary linkage. Note the location of the spring in relation to the distributor base before removing.
Remove the spring by lifting it over the end of the crankshaft. (Do not spread.)
Apply Type "D" Lubricant with a narrow applicator to the spring bearing area on the crankshaft. Apply upward from the seal approximately 1/8". Apply no higher than 1/4" as it could be picked up by the breaker points.
PAGE 2 SERVICE BULLETIN SB-1165 JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
Replace the cut off spring over the end of the crankshaft, flat side down.
Install the distributor base over the spring being sure the coiled part of the spring is located between the nylon oiler wick clip and the reverse cut off ground contact.
Reassemble distributor: rotor, cap, alternator, wave washer and flywheel.
NOTE: Always slide cut off spring over end of crankshaft. Never pull the spring from the shaft in such a way as to spread the spring. This will cause the spring to lose its tension on the crankshaft resulting in an erratic running engine.
OMC Type "D" Lubricant is available in 1/2 oz. tubes from your Parts Distributor under part number 172121.
JOHNSON MOTORS J. R. Penland Service Promotion Manager
JRP/rkm
NOTE: Post on your VX, 60 H.P., V4, 80 H.P. and VM, 100 H.P. Indexes under the heading "Ignition".
Please be advised that in the 1968 100 H.P. service manual page 4-8 figure 4-20, it is indicated that there is a groove in the crankshaft for the cut off spring. This is incorrect. Please correct your manual accordingly.
Historical references
Factory bulletin SB-1165 identifies spring 313743 and OMC Type "D" lubricant 172121 and corrects figure 4-20 on page 4-8 of the 1968 100 HP service manual.