Johnson Service Bulletin SB-1167 - Torque-Bendix Drive Locknut

Issued July 1968, this bulletin updates the recommended starter-drive locknut torque on Johnson V-4 outboards to prevent loosening from vibration.

Johnson Motors Service Bulletin factory letterhead
July, 1968
SUBJECT:CHANGE IN TORQUE-BENDIX DRIVE LOCKNUT
V-4 OUTBOARDS

We have received several reports from the field of the locknut on the starter drive vibrating loose. As a result of these complaints and our own tests, we have found that a moderate increase in the applied torque on this nut will eliminate this problem. Accordingly, we are raising the recommended torque on this nut from 20 to 25 foot-pounds to 25 to 30 foot-pounds.

We strongly recommend that you check the torque of any motors brought in for service. We also recommend that you note this change in your service manual torque chart.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK/rkm

NOTE:  Post on all V-4 Indexes under the heading "Electrical".

Historical service reference

Updated specification: Torque-Bendix starter-drive locknut, V-4 outboards: 25-30 ft-lbs (previously 20-25 ft-lbs). This is the factory specification published in July 1968.