Johnson Service Bulletin SB-1170 - Installing Prop Nut and Cotter Pin

Issued in August 1968, this bulletin describes a correction for loose cotter pin engagement on the propeller nut of Johnson TR(L)-10 55 H.P. outboards. It specifies brass washers beneath the propeller nut and cautions against adding thrust washers ahead of the propeller thrust bushing.

Johnson Motors Service Bulletin gray factory letterhead

August, 1968

SUBJECT:
INSTALLING PROP NUT AND COTTER PIN
ON MODEL:
TR(L)-10, 55 H.P.

Several complaints have been registered relative to the fit of the #314502 Cotter Pin in that it does not fit snugly in the notches of #314503 Propeller Nut. The problem is that the cotter pin hole in the prop shaft is too far aft. Redesign of the prop shaft has corrected this.

All units on which this problem exists can be corrected by adding #305142 Brass Washer or washers under the propeller nut. Do not add Thrust Washers #313925 in front of the propeller thrust bushing as this practice backs the propeller away from the gearcase.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK/rkm

Historical parts reference

The bulletin identifies cotter pin 314502, propeller nut 314503, brass washer 305142, and thrust washer 313925. The thrust washer is specifically not the recommended correction.